How to adjust compressing pressure for SHB1 series

 
Increasing or decreasing the compressing pressure will directly affect the density of your bale. Please follow the steps below to learn how to adjust compressing pressure on your baler. Remember to refer to the safety working pressure stated on your Operator Instruction Manual to ensure you don’t go above the limit.
 

Pressure adjustment steps for Manual Tie Horizontal Baler:

1. Turn on the power and start the motor.

2. Adjust “A” (refer to picture) by turning the plastic knob as per the red arrow during baling. Observe the pressure gauge at the same time to monitor the increase of pressure. For your info, turning the knob anti-clockwise will decrease the pressure.

3. However, if the pressure did not go up after adjusting “A”, please go to “B” and turn the knob as per the red arrow.

4. Always refer to the pressure gauge while turning the knob to monitor the increase or decrease of pressure, and ensure it is within recommended safety working pressure as stated on your Operator Instruction Manual.

NOTE:
– Adjust the valve slowly to achieve desired pressure, check the pressure gauge at all time so as to not increase/decrease too much at one time.

– The recommended pressure has already been set at our factory before delivery. Therefore, do not make any adjustment to pressure unless it is necessary.