approved iso

How to adjust compressing pressure for SHB1-WS series (25T & below)

Increasing or decreasing the compressing pressure will directly affect the density of your bale. Please follow the steps below to learn how to adjust compressing pressure on your baler. Remember to refer to the safety working pressure stated on your Operator Instruction Manual to ensure you don’t go above the limit.

Pressure Adjustment for Scale Weighing Horizontal Bagging Baler

Pressure adjustment steps for Scale Weighing Horizontal Bagging Baler:

1. Start the motor.

2. Adjust overflow valve (see B) by turning knob as per the red arrow during baling, you will see the pointer of pressure gauge (see A) increases during the process. Turning the knob in opposite direction and you will see a decrease of pressure.


– Adjust the valve slowly to achieve desired pressure, check the pressure gauge at all time so as to not increase/decrease too much at one time.

– The recommended pressure has already been set at our factory before delivery. Therefore, do not make any adjustment to pressure unless it is necessary.