How to adjust compressing pressure for SHB1-WS series (30T & above)

 
Increasing or decreasing the compressing pressure will directly affect the density of your bale. Please follow the steps below to learn how to adjust compressing pressure on your baling machine. We strongly advise you to refer to the safety working pressure stated on your Operator Instruction Manual to ensure you don’t go above the limit.
 

Pressure adjustment steps for Heavy Duty Horizontal Bagging Baler:

1. Turn on the power and start the motor.

2. Adjust overflow valve (2) by turning the plastic knob clockwise (as per the red arrow) during baling. Observe the pressure gauge at the same time to monitor the increase of pressure. For your info, turning the knob anti-clockwise will decrease the pressure.

3. However, if the pressure did not go up after adjusting overflow valve (2), please go to overflow valve (1) and turn the knob clockwise as per the red arrow. Observe the pressure gauge at the same time to monitor the increase of pressure.

NOTE:
– Adjust the valve slowly to achieve higher pressure, check the pressure gauge at all time so as to not increase too much at one time.

– The recommended pressure has already been set at our factory before delivery. Therefore, do not make any adjustment to pressure unless it is necessary.