How to adjust compressing pressure for SVB2-S series
Increasing or decreasing the compressing pressure will directly affect the density of your bale. Please follow the steps below to learn how to adjust compressing pressure on your baler. Remember to refer to the safety working pressure stated on your Operator Instruction Manual to ensure you don’t go above the limit.
Pressure adjustment steps for Mini Baler:
1. Turn on the power and start the motor.
2. Use a wrench to loosen the nut on overflow valve (see B). Adjust overflow valve by using a wrench to turn clockwise (circled in red) during baling. You will see the pointer of pressure gauge (see A) increase during the process. Turning the valve anti-clockwise, you will see a decrease of pressure.
NOTE:
– Adjust the valve slowly to achieve higher pressure, check the pressure gauge at all time so as to not increase too much at one time.
– The recommended pressure has already been set at our factory before delivery. Therefore, do not make any adjustment to pressure unless it is necessary.
– Do remember to use the wrench to tighten the nut when done.